Lynx Cartridge Pi 'HAT'
$USD 44.99
With the Lynx Cartridge Pi 'HAT' you are able to both read and write* Atari Lynx game cartridges.
Requires a Raspberry Pi with a 40 pin GPIO connector (not provided). See this page for information on how to set up and use the Raspberry Pi device, including additional software for reading/writing Lynx carts.
Also check this out - How to make a homebrew Atari Lynx cartridge.
⚠️ Note: A compatible flash cartridge is required for writing data, original game cartridges are read-only.
Package Contents
| Fully Assembled Kit | DIY Kit | |
|
1x Assembled Lynx Pi 'HAT' board 2x 11mm M2.5 stand-offs 4x 8mm M2.5 screws Includes the Atari Lynx cartridge connector. |
- or - |
1x Lynx Pi 'HAT' PCB 1x 40 pin GPIO connector 2x Lynx connector screws 2x 11mm M2.5 stand-offs 4x 8mm M2.5 screws 2x MCP23S17-E/SO 28 Pin SOIC IC 2x 100nF 0805 Multilayer Ceramic SMD Capacitor 25V 1x 330Ω 0805 Thick Film SMD Resistor (R1) 1x 470Ω 0805 Thick Film SMD Resistor (R2) 1x 2.2V 0805 Green LED (ACT) 1x 1.8V 0805 Red LED (ERR) DOES NOT include the Atari Lynx cartridge connector. |
LNX-PIHAT-DIY Circuit_Board
4 Items
Data sheet
- Compatibility
- All official Atari Lynx cartridges and most homebrew cartridges.
Specific References
- MPN
- 853400
You might also like
Customers who bought this product also bought:
