If your Lynx 2 speaker is blown (happens if the power plug is accidentally plugged into the headphone jack).

Or if it just sounds much too quiet for your liking and you already replaced the capacitors.

Or you want a speaker that gives you more bass and clarity vs the original.

This is the speaker for you!

Note: Some speakers will come with pre-soldered wire leads, you will need to still uses the original speaker connector for these, with some shrink wrap around where you solder the leads from the connector to the speaker leads.

Check out the video below of when we tested it and compared to a standard Lynx 2 speaker.

Installation Instructions

Desolder the connector on your original Lynx 2 speaker and solder it to the replacement speaker, keeping the same orientation of the wires.

Use a small flathead screwdriver to lift the locking tabs holding the original speaker in place.

Push the new speaker into the locking tabs.

Don't forget the plug the new speaker in!

Package Contents

• 1x Speaker